Axkid Duofix Bedienungsanleitung Seite 12

Head Support Brake On Headrest
The headrest on your Duofix is equipped with a head support brake. This can be used if you
22
want to keep the headrest in a fixed position. To activate the head support brake, pull the
harness adjustment strap until the headrest is at the desired height, you will hear a faint "click"
sound from the headrest as it locks into position. Check that the headrest can not be pulled down any
further and activate the headrest brake by moving the lever (i) across to the right.
WARNING: Do not pull up the headrest with the parking brake activated.
Forward-Facing 9-18 Kg With Seat Belt
Installing The Seat
Make sure the seat' s angle is in position (i). If not, press the adjustment lever (K) and tilt the seat
23
forward until it stands straight up.
Place your Duofix on the car seat. Unzip the seat cover where the top belt guides are (A). Screw
24
open the nut on the top belt guide. Pull the car' s seat belt and place the shoulder strap into the
top belt guide (A) on the upper side of the seat and close the nut.
Pull the seat belt straight vertically down, on the backside, to the nearest hole in the back of the
25
seat.
Feed the car' s lap belt and shoulder belt through the first hole, across the front of the chair
26
between the seat cover and the seat body and then back through the second hole.
27 Pull both belts horizontally across chair and fasten the seat belt in the belt buckle.
Remove all the slack from the seat belt and secure it with the lock-off clip (X) just above the top
28
belt guide (A).
Please make sure that the belts haven't tangled up or been folded anywhere. Also make sure that
both shoulder and lap belt are securely fastened everywhere. Use your own weight to press down on
the chair in order to automatically fasten the seat belt further.
Never install a child restraint in a passenger seat
where an active airbag is fitted.
11