Electrolux IK283SA Benutzerinformation Seite 15

Problem
The compressor operates
continually.
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the FastFreeze
Shopping, or after chang‐
ing the temperature.
Water flows into the refrig‐
erator.
Temperature cannot be
set.
Possible cause
Temperature is set incor‐
rectly.
Many food products to be
frozen were put in at the
same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FastFreeze function is
switched on.
The Shopping function is
switched on.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent that
water flows into the water
collector.
The FastFreeze or Shop‐
ping function is switched
on.
ENGLISH
Solution
Refer to "Operation" chap‐
ter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature be‐
fore storing.
Refer to "FastFreeze func‐
tion".
Refer to " Shopping func‐
tion".
Refer to "Closing the door".
Position the water drain‐
age plug in the correct
way.
Wrap the food products
better.
Refer to "Operation" chap‐
ter.
The compressor starts af‐
ter a period of time.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets au‐
tomatically to set the tem‐
perature. Refer to "Fast‐
Freeze function" or " Shop‐
ping function".
15