Technical Data - HANSGROHE iBox universal Montageanleitung

Concealed installation
The rotation symmetrical body is horizontal and vertical
usable. Only exception installing the bath-shower mixer
with integrated safety combination. In this case only a
verticaly installation is possible. Install the iBox always
above the bath-tup. If parts of the iBox will broken, the
water can flow in there!
The iBox is suitable for both bath and shower applica-
tions. When using the bath-shower mixer / thermostatic
mixer with shut-off and diverter unit outlet, the lower
outlet must have priority. If you need only one outlet,
choose either the top or the bottom outlet and connect it.
Close the unused outlet with a plug.
The hot and cold supplies must be of equal pressures.
Install body with the hot water supply left and cold water
supply right.
Depth of fitting: 80 mm to 108 mm.
extension 25 mm: #13595000
Extension Set 22 mm (when wall is not deep enough).:
#13593000 / #13596XXX / #13597XXX /
#15597000 / #19427000 / #97407XXX /
#98860000 / #13601000 / #13604000
The iBox can depending on the building application be
mounted in different ways, Installation examples please
see page 62 and 63.
A Direct wall installation.
B Direct wall installation with 10 mm adjustable mount-
ing studs.
C Installation on carrier system.
D Hollow wall installation.
E Brick wall installation.
F Installation with fixation set #96615000
Installation examples with measurements and pipe
dimensions can be found starting on page 68. The used
symbols are explained on pages 67.
6
English
The installation dimensions stated in these installation
instructions are ideal for people of approximately 1800
mm in body height. The dimensions can be altered if
required. In this case, pay attention to the fact that a
change of installation height will also change the mini-
mum height, and that the altered mounting dimensions
must be taken into consideration. The consumption was
measured in combination with the appropriate fittings
(thermostat/mixer/in-wall valve) to reflect actual applica-
tion in practice.
Installation tip
To install the supply pipes, fix the iBox with a pipe in a
vice.
Flush piping system
To complete the installation flush out both hot and cold
water supply. The arrows on the flush body are showing,
which inlet is connected with which outlet, for example
cold water suply with outlet 1 and hot water supply with
outlet 2. If only one outlet is in use, after first flushing the
flush body must turned about 90º.
iBox in combinaton with an Exafill bath
filler with overflow and waste (see page
66)

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Centre distance:
Connections:
Rate of flow by 0,3 MPa:
Shower mixer:
Thermostatic mixer:
Thermostatic mixer with shut off unit:
Thermostatic mixer with shut off and
diverter unit:
Thermostatic mixer Highflow (Outlet 1+2):
iControl:
Bath-shower mixer:
Bath-shower mixer with integrated
safety combination:
Assembly see page 60
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 70°C
65°C
R¾
cold right - hot left
32 l/min
37 l/min
26 l/min
26 l/min
58 l/min
30 l/min
31 l/min // 24 l/min
25 l/min // 24 l/min