Outputs; Inputs - Dimplex WPM EconPlus Bedienungsanleitung

Configuring the Heat Pump Heating System

6.2 Outputs

Depending on the system configuration, the "Outputs" menu
displays the "OFF or ON" status display for the following outputs:

6.3 Inputs

Depending on the system configuration, the "Inputs" menu
shows the "Contact open or closed" status display for the
following digital inputs:
Display
Always
2 compressors
Cooling function
Air-to-water HP
Always
Passive cooling function
Bivalent or mono energy
Bivalent
Bivalent
Heating circuit 3
Heating circuit 3
Always
Cooling function
Status display of all digital inputs
"Contact open" means that a fault has occurred (setting LP
pressure switch NC contact
"Contact open" means that a fault has occurred (setting HP
pressure switch NC contact)
"Contact closed" denotes defrost end
"Contact open" means that a fault has occurred (insufficient flow
rate)
"Contact open" means that a fault has occurred.
"Contact open" means that a fault has occurred.
"Contact open" means that a fault has occurred.
"Contact open" means that a fault has occurred.
"Contact open" denotes a utility block.
"Contact open" denotes a block.
"Contact closed" means that a fault has occurred.
Display
Heating circuit 2
Heating circuit 2 or
cooling operation with silent-
only cooling with reversible HP
Heating circuit 2 or
cooling operation with silent-
only cooling with reversible HP
Always
Passive cooling function
Cooling function
Passive cooling function
Hot water
Hot water
Sensor
Flange heater
Swimming pool
Circulation
1
1
6.3
Always
Always
Air HP without hot
gas defrosting
Pressure sensors
No
Brine HP rev.
Water HP
Air HP
BW or WW HP
Always
Always
Always
Always
LP brine
EN-19