Connecting To The Battery - NOCO Genius G15000 Betriebsanleitung

Mode
Jump
CHARGE
battery's state-of-charge (SOC), only the JumpCharge
progress. Once the 100% green LED is illuminated solid,
and the 25%, 50% and 75% Charge LEDs are "off", the
JumpCharge process is completed and your are ready to
start your vehicle. For optimal results, allow JumpCharge
to complete its five (5) minute charge.
If unsuccessful when starting your vehicle, let the battery
rest for fifteen (15) minutes and try JumpCharge again.
Most vehicles will start with one (1) JumpCharge, but
larger vehicles with dual battery systems, may require
an additional JumpCharge. If when pressing the
JumpCharge button, an Error Condition (Error LED and
Standby LED flashing) illuminates, the battery is below
2-volts. To JumpCharge a battery below 2-volts, press
and hold the JumpCharge button for three (3) seconds,
and JumpCharge will being jumpstarting your battery.
CAUTION. USE THIS MODE WITH CARE. THIS MODE
IS FOR 12-VOLT LEAD-ACID BATTERIES ONLY. DO
NOT USE JUMPCHARGE MORE THAN TWO (2) TIMES
WITHIN A TWENTY-HOUR (24) HOUR PERIOD. IF TWO
(2) JUMPCHARGES CANNOT SUCCESSFULLY START
YOUR VEHICLE, HAVE YOUR BATTERY EVALUATED
BY A LOCAL BATTERY STORE.

Connecting to the Battery.

Do not connect the AC power plug until all other
connections are made. Identify the correct polarity of
the battery terminals on the battery. The positive battery
terminal is typically marked by these letters or symbol
(POS,P,+). The negative battery terminal is typically
marked by these letters or symbol (NEG,N,-). Do not
Explanation
Delivers 20A for five (5) minutes to
jumpstart your dead vehicle battery.
When selected, a white LED will
illuminate. (Red Manual Mode)
5Min | 20A | 50-400Ah Batteries
6