Checking The Blade - Echo RM-510ES Bedienungsanleitung

Maintenance and care
Angle transmission

Checking the blade

Installing nylon line cutter (option)
spacer can easily draw out from the flexible shaft assembly. -
Use the same grease as the angle transmission's. - When re-
assemble, it is preferable to fit the power transmission shaft
(R) reversely, but the spacer is fitted on the rear handle as-
sembly side of the powertransmission shaft (R) at all times.
1. Remove the plug (A) and drain screw (B) from the angle
transmission (C).
2. Add grease into the transmission until old grease is pushed
out. If necessary, use a low pressure pump.
NOTE
Use good quality lithium multi grease.
3. Reinstall the drain screw and plug.
Use only blade designated for this model by the manufacturer.
When a crack is noticed on the blade, do not use it but replace
with a new one.
Ensure that the blade is correctly fitted in accordance with the
instructions.
When the cutting blade becomes dull due to wear reverse it for
further use.
When chip or bend occurs on the blade, vibration will increase.
Replace with new one.
When filing the blade file 3 cutting edges evenly using a flat file
as shown in the illustration. Otherwise, the balance will be lost
and vibration will increase.
There are two types of shields: namely the one used exclu-
sively for nylon line cutting head and the other one used exclu-
sively for metal blade. When using nylon line cutting head, use
the shield for nylon line cutting head.
1. Fully loosen the bolt (A) on the right side of the bracket (B)
to slide the shield. The bolt itself cannot be removed from the
bracket.
2. Pushing the button (C), slide the shield (D) to the left and re-
move it.
3. Put shield of other type (E) into groove and slide it to the right
until it stops. Be sure to tighten the bolt.
24