Input, Output And Control Section - dB Technologies ES 1002 Bedienungsanleitung

INPUT, OUTPUT AND CONTROL SECTION

1. Balanced MIC/LINE Input (CH1)
This is an XLR or TRS (balanced or unbalanced) combo connector input.
It allows you to connect a microphone or line input. See chapter 3 for details of the channel settings.
2. Master Volume Control
General audio output volume of the ES1002 transducers.
It does not affect the LINK output level.
3. Input sensitivity switch (Line/Mic)
In the Mic position, it lets you use a microphone connected to the input [1].
In the Line position, you can use a mixer or line input connected to the connector [1].
4. Link Output
This is an audio output (XLR connector).
It repeats the CH1 [1] input signal to a second ES1002 system (or other speaker/monitor with a "Line" input).
Note that the repeated audio signal is not affected by the local volume control [2].
Remember to set the switch [3] to the "Line" position on the second ES1002 system.
5. AUX Input (CH2)
This is a stereo RCA input.
It lets you connect an audio device with a L-R output and RCA connectors (e.g. MP3 player).
6. AUX VOLUME
This lets you adjust the volume of the CH2 input [5] separately
7. Status LED
Limiter: this comes on when the internal protection circuit triggers.
On-signal: flashes briefly at power-on, and flashes intermittently to indicate that there is an input audio signal
8. DSP PRESET
These presets adapt the sound emitted by the system to specific usage conditions.
See chapter 3, FIRST SWITCH-ON, for further details.
ES-1002
28
English
Cod. 420120265 REV. 1.0