Building Into An Existing Hearth - Dovre VISTA 700i Einbauanleitung Und Gebrauchsanweisung

6. Right baffle plate
7. Left rear inner plate
8. Centre rear inner plate
9. Right rear inner plate
10. Left stove base plate
11. Middle stove base plate
12. Right stove base plate
13. Stove base plate cover
14. Ashtray
Remove the interior parts.
a. Lift the left baffle plate holder (4)
b. Remove the left inner plate (3)
c. Let the left baffle plate holder (4) drop until it is
on the stove base plate
d. Remove the left baffle plate (5)
e. Remove the baffle plate holder (4)
f. Remove the right baffle plate (6)
g. Remove the right inner plate (2)
h. Remove the centre inner plate (8)
i. Remove the left rear (7) and right rear (9) inner
plates
j. Remove the fire basket (1) by lifting it up
k. Remove the stove base plate cover (13) and
the ashtray (14)
l. Remove the left (10) and right (12) stove base
plates
m. Remove the middle stove base plate (11)
Place the parts back in the reverse order.
Connecting the fan to the mains
The fireplace insert is supplied with two built-in fans
and with a separate revolution control unit. In addition,
the appliance is equipped with a thermostat switch
that switches on and off the fan at a fixed indicated
temperature.
The fans can be easily disconnected electrically by
the use of a plug, so that the fan plate can be
removed.
These parts must be connected to the mains accord-
ing to the connection scheme in appendix 2.
The connection diagram is specific to the
model.
Have the connection made by a qualified
installer.
The fireplace insert is provided with a three-
core cable.
12
The fireplace insert must be isolated from the
mains by a 2-pole switch.
Ensure that the fireplace insert is properly
earthed.
Building into an existing
hearth
To build the stove into an existing hearth, follow the
steps below:
1. Place the appliance at the right height and level it.
Keep the electrical cable of the appliance free.
2. If you are going to put an outside frame around the
appliance, you should fit the included magnets to
the sides of the appliance according to the draw-
ing.
1
2
3. Close the base of the flue with a non-combustible
material.
4. Make an opening in the base for the extraction
duct with a diameter of 150 mm (700i) or 180 mm
(800i).
5. Remove the connection collar via the inside of the
appliance.
6. Use a flexible pipe or a connection elbow of 45°.
7. Place the appliance in the opening.
8. Pull the connection pipe to the inside.
9. Attach the connection collar to the flexible pipe or
elbow.
10. Attach the connection collar back to the appliance.
The following figure depicts an example of the place-
ment of a built-in stove in a hearth that has been con-
structed according to the above instructions and
requirements.
Subject to change because of technical improvements
09-200021-231