Installing The Transmitter Batteries; Installing The Vehicle Battery; Removing The Vehicle Body - ECX TORMENT ECX4000S Bedienungsanleitung

InstallIng transMItter BatterIes
Install 4 AA alkaline batteries into the transmitter,
following the instructions provided for your radio system.
We recommend using only alkaline AA batteries in the transmitter,
however, it is possible to use rechargeable Ni-MH batteries.

reMoVIng the VehIcle Body

InstallIng the VehIcle Battery

1. Loosen the thumb nuts to remove the battery strap.
2. Install the battery.
3. Reinstall the battery strap.
4. Tighten the thumb nuts to secure the battery strap.
5. Connect the battery.
If desired, you can put foam blocks
(ECX2015) in front of the battery so
the weight of the battery increases
rear traction or in back of the battery
to increase steering response.
cautIon: If using rechargeable batteries, charge
only rechargeable batteries. Charging non-rechargeable
batteries may cause the batteries to burst, resulting in
injury to persons and/or damage to property.
NEVER install damaged batteries, batteries of mixed types or batteries
of different ages in the transmitter. Remove exhausted batteries.
NEVER store the transmitter with batteries installed.
EN
5