NEILPRYDE RS:RACING EVO9 Bedienungsanleitung Seite 4

3. Putting the cams onto the mast
a. Set your boom plenty long enough
to fit around the mini-batten below
the integrated compact clew. Then
put the boom on the mast and walk
around the clew side of the sail. Pivot
the boom tail up and slide the boom
to the recommended setting into the
opening and apply about 5cm
out-haul from Neutral.
b. Open the zippers on the luff sleeve
and release ALL the down-haul
before pushing the cams onto the
mast.
06
c. Starting with the top cam put one
hand on the sail body just on the
edge of the mast sleeve, while your
other hand goes under the cam
supporting the cam with whole palm
of your hand. Push down gently with
the hand on the edge of the sleeve
while the hand under the cam
pushes the cam forward a little and
it will go on to the mast easily. (If it
doesn't go on easily then you may
have too much outhaul.)
d. Do this for all the cams except the
bottom one. For the bottom cam put
one hand into the zipper and push
down onto the sail body, with the other
hand again push the cam forward and
up onto the mast.
e. After all the cams are on close the zips.
4. Finish Rigging
a. Apply downhaul and outhaul to your
preferred setting.
b. Loop the tack strap around the base
and apply tension.
Check your setup and tune your sails
and then you are ready to race!
07