Specifications - Makita BTD140 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Red part
1-2. Button
1-3. Battery cartridge
2-1. Switch trigger
3-1. Lamp
4-1. Reversing switch lever
6-1. Bit
6-2. Sleeve

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model BTD130F,BTD140,BTD141
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model BTD142
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Model BTD130F
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Explanation of general view
7-1. Bit
7-2. Bit-piece
7-3. Sleeve
8-1. Hook
8-2. Screw
8-3. Groove
10-1. Limit mark
11-1. Rear cover
Model
Machine screw
Standard bolt
High tensile bolt
-1
)
Overall length
Net weight
Rated voltage
) : 90 dB(A)
pA
) : 101 dB(A)
WA
) : 89 dB(A)
pA
) : 100 dB(A)
WA
2
) : 14.0 m/s
h
BTD130F
0 - 2,400
146 mm
1.4 kg
D.C.14.4 V
ENE033-1
Uncertainty (K) : 1.5 m/s
Model BTD140,BTD141
Work mode : impact tightening of fasteners of the
ENG905-1
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model BTD142
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENG900-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
3
11-2. Screws
12-1. Spring
12-2. Arm
12-3. Recessed part
13-1. Carbon brush cap
14-1. Hole
14-2. Carbon brush cap
BTD140 BTD141
4 mm - 8 mm
5 mm - 14 mm
5 mm - 12 mm
0 - 2,300
0 - 3,200
145 mm
1.3 kg
D.C.18 V
2
2
) : 17.0 m/s
h
2
2
) : 15.5 m/s
h
2
BTD142
146 mm
ENG901-1