Aventics EV03 Betriebsanleitung Seite 16

AVENTICS | EV03 | R414008223–BAL–001–AA | English
Assembling on a mounting plate
Fastening with screws in the upper through holes
20
Fig. 5: Mount the EV03 with screws through the upper through holes
on a mounting plate.
O Slide the cylinder head screws (WS 4) into the upper through holes (20) and the
mounting plate (19).
O Tighten the cylinder head screws.
Tightening torque: 6 Nm
Fastening with screws in the through holes on the side
19
Fig. 6: Mount the EV03 with screws through the through holes on the sides
on a mounting plate.
O Slide the cylinder head screws (WS 4) into the through holes on the side (21) and
the mounting plate (19).
O Tighten the cylinder head screws.
Tightening torque: 6 Nm
19
21
00135409
Fastening with a mounting kit for mounting plate
24
23
22
Fig. 7: Mounting kit for mounting plate assembly
A mounting kit R414002582 is needed to assemble the device on a mounting plate.
The mounting kit for the mounting plate contains:
W
2 mounting panels (22)
W
2 toothed lock washers (23)
W
2 cylinder head screws (WS 4) (24), tightening torque: 6 Nm
1. Assemble the mounting kit for the mounting plate as shown in Fig. 7.
The mounting panels (22) catch in the recesses and can thus be aligned.
2. Mount the device to a mounting plate with two mounting panels
Assembling on a rail
25
Fig. 8: Mounting kit for rail assembly
To assemble the device on a rail, you will need the TH35-7.5 rail mounting kit
R414002583. The mounting kit includes:
W
1 mounting plate (25)
W
1 cylinder head screw (WS 4) (26), tightening torque: 1 Nm
1. Assemble the mounting kit as shown in Fig. 8.
The mounting panel (25) catches in the recesses and can thus be aligned in three
directions at right angles to the device.
2. Fasten a single device with one mounting plate onto a rail.
24
23
22
26
00125294
15