Horizon Hobby Evolution 10GX2 Bedienungsanleitung Seite 6

EN
Adjusting the Throttle Opening
1. Lower the throttle and center the throttle trim.
2. Adjust the length of the throttle linkage until
the throttle is open 1mm.
3. Move the throttle stick up to confirm the
throttle opens. If the throttle does not
open, reverse the throttle channel in your
transmitter.
Attaching the Fuel Lines
1. Connect medium diameter tubing to the
carburetor and the fuel tank supply line.
Attaching the Propeller and Spinner
1. Remove the prop nut and prop washer from
the crankshaft.
2. Install the spinner backplate, followed by
the propeller, prop washer and prop nut.
3. Cover the propeller with a cloth and use an
adjustable wrench to tighten the prop nut.
4. Move the throttle stick and throttle trim
down to confirm the throttle closes.
5. If you reversed the throttle channel in your
transmitter and you are using a 2.4GHz radio
system, you must re-bind your radio system
to set the correct failsafe position.
2. Connect medium diameter fuel tubing to
the vent line in the fuel tank. Route the
other end of this line to the outside of the
fuselage.
3. If using a three-line tank, connect medium
diameter fuel tubing to the third line and
route this line to a convenient location
for fueling/de-fueling your model. We
recommend using a fuel filler like the one
Crankcase
included in the Hangar 9
Pressure Line
"T" Fitting and Overflow Fitting (HAN116),
Fuel Inlet Line
which also includes a vent line connector.
We also recommend using medium diameter
FKM fuel tubing for all plumbing in your fuel
setup.
4. Install the spinner cone. Make sure the
spinner cone is not touching the propeller.
Trim the propeller opening if necessary.
5. Tighten the spinner screw(s) to secure the
spinner cone.
Recommended propellers
10 x 6–13 x 8
12 x 6 has tested to be the best sport
propeller for all-around performance, although
the performance is very good throughout the
recommended range.
6
Fuel Filler with
®