Appendix; List Of Parameters En - Abicor Binzel iROB Control Betriebsanleitung

13 Appendix

13 Appendix
13.1 List of parameters
Pos.
0
1
2
3
4
5
6
7
10
11
12
15
16
19
20
21
22
Tab. 14
EN - 24
Designation
Saving and exiting
Reset (saved programs are retained)
Characteristic number
The parameters are transmitted to the 7-segment display by pressing Softkey 2.
Wire feeder speed setpoint
Setpoint of the current welding current
Recommended material thickness to be processed
A dimension to be expected in horizontal fillet while observing the preset welding
speed.
Arc length correction
Gas preflow
Soft start (slow wire feed speed)
Wire acceleration
Wire burn-back
Gas postflow
Percentage of double pulse high-current phase
Wire feeder speed double pulse low-current phase
Double pulse frequency (0.1 to 5 Hz)
Arc length correction double pulse base-current phase
Parameter list
iROB Control
BAL.0333.0 • 2017-08-31