Dismounting; Disposal - Abicor Binzel iROB Control Betriebsanleitung

iROB Control

11 Dismounting

1 Pull the BUS plug from the power source.

12 Disposal

When disposing of the system, local regulations, laws, provisions, standards and guidelines must be
observed. Observe the regulations on the disposal of electronic scrap and dispose of it at your local waste
disposal site (e.g. recycling centre).
For the product to be properly disposed of, it first must be dismounted. Please take note of the following
information:
 See 11 Dismounting on page EN-23
12.1 Materials
This product is mainly made of metallic materials which can be melted in steel and iron works and are, thus,
almost infinitely recyclable. The plastic materials used are marked in preparation for sorting and separation
of the materials for later recycling.
12.2 Consumables
The control does not require any consumables. However, the operating instructions of the other welding
components must be observed.
12.3 Packaging
ABICOR BINZEL has reduced the packaging for shipping to a minimum. Packaging materials are always
selected with regard to their possible recycling ability.
BAL.0333.0 • 2017-08-31
11 Dismounting
EN - 23