Classification Of The Warnings En; Product Safety En - Abicor Binzel iROB Control Betriebsanleitung

2 Safety
2.4 Classification of the warnings
The warnings used in the operating instructions are divided into four different levels and are shown prior to
potentially dangerous work steps. Arranged in descending order of importance, they have the following
meaning:
Describes an imminent threatening danger. If not avoided, this will result in fatal or extremely critical
injuries.
Describes a potentially dangerous situation. If not avoided, this may result in serious injuries.
Describes a potentially harmful situation. If not avoided, this may result in slight or minor injuries
NOTICE
Describes the risk of impairing work results or potential material damage to the equipment.
2.5 Product safety
• The product has been developed and manufactured in accordance with state-of-the-art methods and the
recognized safety standards and guidelines. These operating instructions warn you against
unavoidable residual hazards for user, third parties, devices or other material property. Disregarding
these warnings may result in risks to the life and health of personnel, environmental damage or material
damage.
• The product may only be operated in unchanged and technically perfect condition, within the limits
described in these instructions.
• Always observe the limit values specified in the technical data. Overloading leads to destruction.
• Safety devices on the device may never be dismounted, bridged or bypassed in any other way.
• During welding work outdoors, use suitable protection against the effects of weather.
• Check the electrical device for any damage and for proper functioning in accordance with its
designated use.
• Never expose the electrical device to rain and avoid a moist or wet environment.
• Protect yourself from electrical accidents by using insulating mats and wearing dry clothing.
• Never use the electrical device in areas subject to fire or explosion hazards.
• Arc welding may cause damage to eyes, skin and hearing! When working with the device, always
wear the prescribed protective equipment.
• Any metal vapours, especially lead, cadmium, copper and beryllium are harmful to health! Ensure
sufficient ventilation or extraction. Always ensure compliance with the legal limit values.
• Rinse work-pieces that have been degreased with chlorinated solvents with clear water. Otherwise there
is a risk of phosgene gas formation. For the same reason, no degreasing baths containing chlorine must
be placed in the vicinity of the welding area.
• Adhere to the general fire protection regulations and remove flammable materials from the surroundings
of the welding work area, prior to starting work. Keep appropriate fire extinguishing equipment ready
at the workplace.
EN - 4
DANGER
WARNING
CAUTION
iROB Control
BAL.0333.0 • 2017-08-31