Functional Description; Putting Into Operation; Electric Shock; Connecting The Remote Control En - Abicor Binzel iROB Control Betriebsanleitung

iROB Control

5 Functional description

The remote control iROB Control is an electronic instrument for parameter setting of the welding power
source iROB Pulse. Communication with the welding power source takes place via a CAN bus.
For entry, the device is equipped with a rotary button with pressing function, referred to hereinafter as
<Selector switch>. In addition, there are four softkeys whose function will change depending on the screen
displayed. Chapter 7.2 shows an overview of the displays and explains the associated softkey assignments.

6 Putting into operation

Electric shock

Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• Please take note of the following instructions:
• The system may only be installed and put into operation by authorized personnel
• Components must only be used in environments with sufficient ventilation.
6.1 Connecting the remote control
The iROB Control remote control may only be used in connection with the iROB Pulse robot welding
power source.
1 Plug the plug on the cable of the remote control into the connection at the front panel of the housing of
the robot welding power source.
The iROB Control starts as soon as the iROB Pulse robot welding power source is switched on by turning
the power switch.
BAL.0333.0 • 2017-08-31
WARNING
 3 Product Description on page EN-6
(in Germany see TRBS 1203).
5 Functional description
EN - 9