Abicor Binzel iROB Control Betriebsanleitung Seite 42

7 Operation
7.5 Selecting the characteristic
 Fig. 2 Remote control operating panel on page EN-10
Press the <key
The left-hand side of the screen shows welding fillers and gas. The right-hand side shows possible wire
diameters. The <Softkey 1> (12) can be used to set the power source in the MSG pulse process to a constant
current intensity (CC) or a constant voltage (CV).
1
2
3
4
Fig. 6
To select a characteristic, proceed as follows:
 Fig. 2 Remote control operating panel on page EN-10
1 <Press key
2 Select a characteristic by pressing <Softkey 3> (10) and <Softkey 2> (11).
3 Press <Softkey 4> (9) to select a wire diameter.
4 <Press key
EN - 14
> (8) to open the display for selecting the characteristic.
1
10
9
5
Welding filler
Wire diameter 6
Gas 7
Number of characteristic 8
Characteristic selection display
> (8).
> (8) to leave the selection display.
3
2
8
7
9
Selected wire diameter
Wire diameter
Filler selection downward 10 Selected filler /
Filler selection upward
iROB Control
4
5
6
Constant current / Constant
voltage in MSG pulse process
shielding gas combination
BAL.0333.0 • 2017-08-31