Cleaning The Filters - Grundig VCC 9771 A Bedienungsanleitung

INFORMATION
Cleaning the cyclone
Open the cyclone lid
remove the dust in it.
Cleaning the filters
Replace your filters at regular intervals according
to the frequency of use. It is recommended that you
replace the filters every 6 months for average use.
While you empty the dust accumulated in the dust
container to clean the container, you need to clean
the motor protection filter, the foam filter and HEPA
filter as well.
Warnings
▪
Do not use appliances producing hot air such as
hair dryer or heater to dry the filters.
▪
Do not install the filters without completely dry-
ing them; otherwise, smell of moisture may occur
during use, water can leak from the back of the
appliance or the filters may get damaged.
▪
Attach the filters into their places after they have
dried.
HEPA filter
1 Push down the rear cover opening latch to open
the cover and remove the HEPA filter by pulling
it from its handle.
2 Press the dust container removal button
remove the dust container
22 ENGLISH
_________________________________
and empty the cyclone to
K
HEPA filter
.
H
3 Remove the HEPA filter located at the back of
the dust container by pulling it from its handle.
HEPA filter
4 You can wash the filters under running water af-
ter shaking them off.
5
If you wash the HEPA filters, dry them at room
temperature (for 24 hours minimum). Do not use
them before ensuring that they are completely
dry.
Foam filters
1 Push down the rear cover opening latch to open
the cover.
2
Remove the HEPA filter by pulling it from its han-
dle.
3 Remove the foam filter behind the HEPA filter.
4 Press the dust container removal button
remove the dust container
5
Remove the HEPA filter located at the back of
the dust container by pulling it from its handle.
6 Remove the foam filter behind the HEPA filter.
7
After shaking if off, wash it under running water,
wring it out gently and leave it to dry (for 24
hours minimum).
G and
G and
.
H