Replacing The Lamp; Closing The Door; Installation - Electrolux EJ2302AOW2 Benutzerinformation

Problem

8.2 Replacing the lamp

Disconnect the plug from the mains
socket.
1. Remove the screw from the lamp
cover.
2. Remove the lamp cover (refer to the
illustration).

9. INSTALLATION

9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
N
ST
T
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
WARNING!
Refer to Safety chapters.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Possible cause
There is no cold air circula-
tion in the appliance.
3. Replace the used lamp with a new
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective
9.2 Location
Solution
Make sure that there is cold
air circulation in the appli-
ance.
lamp of the same power and
specifically designed for household
appliances (the maximum power is
shown on the lamp cover).
"Installation".
door gaskets. Contact the Service
Center.
Some functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only be
guaranteed within the
specified temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer
service or to the nearest
Service Centre
Refer to the assembly
instructions for the
installation.
ENGLISH 25