Cleaning And Care; Switching Off The Appliance - SOLIS VIENTO 3D Bedienungsanleitung

If the sleep mode is enabled, the blue function light behind the
up in the control panel.
Note: If you wish to disable the sleep mode before that, either touch the timer
button for another 3 seconds, until „0" lights up in the display, or switch the
appliance off with the ON/OFF button
4 Oscillation button
With the oscillation button, you can choose from 3 different oscillation motions:
1. Touch once: The appliance moves horizontally from the left to right in an area
of 60°, the blue function light behind the
2. Touch twice: The appliance moves vertically, bottom up, in an area of 70°, the
blue function light behind the
3. Touch three times: The appliance moves in a 3D motion, horizontally and verti-
cally, the blue function lights behind both symbols
If you touch the oscillation button a fourth time, the oscillation motion is deac-
tivated again.
70°
60°
Touch 1 time Touch 2 times
SW I TCHI N G O FF THE AP P LIA N CE
n
•
If you wish to switch the appliance off, touch the ON/OFF button
for the rotor blade to come to a full stop.
• Then, pull the plug. The appliance should always be disconnected from the
power while it is not in use.
58
symbol lights
.
symbol lights up.
symbol lights up.
and light up.
70°
60°
Touch 3 times
and wait
s CLEANING AND CARE
• Before cleaning, moving or storing the appliance, switch the ventilator off with
the ON/OFF button , wait for the rotor blade to come to a full stop and pull
the power plug from the socket.
• The chassis of the ventilator should be cleaned once in a while with a slightly
moist towel. Never submerge the appliance in water and do not spray any water
or another liquid into the appliance!
If you wish to clean the rotor blade, you have to disassemble the appliance
as follows:
1. Unscrew the three screws in the rear grid connecting the read grid with the front
grid.
2. Then, turn the front grid slightly to left and remove it.
3. Then, clock wisely unscrew the screw in the centre of the rotor blade and
remove the rotor blade from the ventilator.
4. Clean the rotor blade with a slightly moist, soft towel. Let all parts dry.
5. Reassemble the appliance in the reverse order:
Counter clock wisely screw on the rotor blade
with the screw, then mount the front grid and turn
it to the right to lock it into place. The tip of the
arrow on the front grid frame has to line up with
the marking on the frame of the rear grid. Then,
clock wisely turn the front grid frame all the way
in so that the two dashes line up.
6. Reattach the front grid to the rear grid using the
three screws.
Only use the appliance if it is correctly assembled!
59