Cleaning And Maintenance - SOLIS DECO HEATER 690 Bedienungsanleitung

CLEANING AND MAINTENANCE

Make sure power is off and the plug is disconnected from the socket before cleaning or maintenance.
Otherwise, it will cause you an electric shock.
1. Clean unit surface:
Clean the surface with damp cloth (or add some detergent). Do not use corrosive detergent or solvent
to clean such as Petrol, Tina etc. Do not swash unit with water.
2. Clean air filter monthly if needed.
• Remove the air filter for cleaning as shown in the following diagram.
Filter Cover
Air Filter
• Do not use chemicals for cleaning.
• Use the soft cloth to wipe the dust. If you use water for cleaning, please make sure the air filter is dry
before reinstall back to the unit.
SOLIS HELPLINE:
044 874 64 14
(Only for customers in Switzerland)
This item stands out due to its long-life cycle and reliability. Despite this though, if a malfunction
ever occurs, simply give us a call. Often a breakdown can be easily and quickly remedied
with the right tip or technique without having to straight away send off the device for repair.
We will give you all the advice and practical support you require.
30
Solis_DecoHeater_Betriebsanleitung.indd 30-31
Disposal
EU 2002/96/EC
In conformity with Directive 2002/96/
EC on waste electrical and electronic
equipment (WEEE), at the end of its life
the unit should be taken to an electrical
appliance collection point for its environ-
mentally friendly disposal.
Safety Switch
(Residual Current Device)
The installation of a residual current
device (safety switch) is recommended
to provide additional safety protection
when using electrical appliances. It is
advisable that a safety switch with a
rated residual operating current not
exceeding 30 mA be installed in the
electrical circuit supplying the appliance.
See your electrician for professional
advice.
SOLIS AG
Solis-House • CH-8152 Glattbrugg-Zurich • Switzerland
Phone +41 44 874 64 54 • Fax +41 44 874 64 99
info@solis.ch • www.solis.ch • www.solis.com
31
21.04.10 10:10