Before First Use - SOLIS VIENTO 3D Bedienungsanleitung

s BEFORE FIRST USE
1. Remove the appliance from its packaging and make sure that it is undamaged,
firmly assembled and ready for use. Should you have any doubts, do not use the
appliance and contact the nearest service centre authorised by Solis.
2. Take care that children do not play with the packaging material, especially with
the plastic bags – risk of suffocation!
3. Place the appliance on a dry, stable surface resp. on a table, as described in the
safety precautions.
4. Remove the battery protection film by pulling it off of the remote.
5. Plug the power plug into a suitable power outlet. You can hear a twofold signal
sound, the current room temperature is shown on the display. You can now use
the appliance as described below.
s STARTING UP
TH E F UN CT IO N BU T T ON S ON TH E C ON T RO L P A N E L
n
A N D O N THE REMO T E
• In general:
The function buttons on the remote control match the function buttons on the
control panel of the ventilator.
Every set function is indicated by the corresponding function light on the control
panel of the appliance. The current room temperature is shown on the display,
or – should the timer be activated – the set time is briefly shown on the display.
56
1 ON/OFF button
If the power plug is connected to the power socket, you can use this button to
switch the appliance on or off. If you touch the
starts working in the lowest speed setting. The current room temperature is
shown on the display and the blue function light behind the number 1 lights up
by the control panel. If you touch the button once more, the appliance switches
back off.
2 Ventilation speed control
You can choose from 3 speed settings. Each touch of the
speed, the corresponding function light illuminates:
1 Function light for low ventilation speed (b)
2 Function light for medium ventilation speed (c)
3 Function light for high ventilation speed (d)
3 Timer button for operation time or sleep mode
a) Setting operation time
If the appliance is switched on, you can set the operation time between 1 hour
and 10 hours at intervals of 1 hour. With each touch of the button you increase
the operation time by one hour, the corresponding number lights up in the dis-
play and the clock symbol flashes to its lower right. A maximum of 10 operating
hours can be set, then the timer starts over at "0".
Once operation time is set, the corresponding number of hours lights up in the
display for a few seconds. After that, the display returns to showing the current
room temperature. The clock symbol to the lower right of the room tempera-
ture display lights up constantly if the timer function is activated. The appliance
switches off after the set number of hours has elapsed.
b) Setting sleep mode
If the appliance is switched on and you touch the timer button for 3 seconds,
sleep mode is activated, meaning the appliance switches on and off at different
intervals for 7 hours. "7" lights up in the display for a few seconds, also the clock
symbol to its lower right. After that, the display returns to the current room tem-
perature. The clock symbol to the lower right of the room temperature display
lights up constantly if the sleep mode is activated.
First, the ventilator works for 1 hour, then it is switched off for 30 minutes. After
that, it is switched on for 30 minutes and switched off for 10 minutes, then, it
is switched on for 5 minutes and switched off for 10 minutes. This cycle repeats
until the operation time of 7 hours has elapsed. The ventilator switches off after
that.
button once, your appliance
button changes the
57