Targus ACP45EU Bedienungsanleitung Seite 6

Targus Universal Laptop Docking Station
Connecting the Docking Station to
Your Computer
After installing the docking station software, you are ready to
connect the docking station to your computer. To do this:
1 Connect the supplied AC power adapter to the AC power jack
on the docking station.
2 Connect one end of the USB cable to the docking station
and the other end into an available USB 2.0 port on your
computer.
WARNING: THE DOCKING STATION WILL NOT FUNCTION
PROPERLY WITHOUT THE AC ADAPTER PLUGGED INTO AN AC
OUTLET.
DO NOT CONNECT ANY DEVICES TO THE DOCKING STATION
UNTIL THE INSTALLATION IS COMPLETED.
Installing the Default Device Drivers
Once you connect the docking station to your computer, the
default drivers begin installing for each of the ports automatically.
NOTE: PLEASE ENSURE YOU HAVE THE LATEST SERVICE
PACKS INSTALLED.
10
Targus Universal Laptop Docking Station
Some hardware devices may prompt you to install the drivers.
To install the drivers:
1 Select Install the software automatically (Recommended) and
click Next.
The Found New Hardware Wizard program begins installing
the hardware drivers.
The Completing the Found New Hardware Wizard screen
appears.
2 Click Finish and repeat as needed for each device.
3 Restart your computer.
LED Status Indicator Lights
Once all device drivers are installed, the USB LED status
indicator lights on the back of the docking station glow when you
connect devices to the docking station.
• Green Tx light illuminates when connected to a network and
the yellow Rx light flashes when data is transmitting to or from
the network.
NOTE: THE DOCKING STATION SUPPORTS HOT SWAPPING OF
THE NETWORK CABLE.
11