Targus ACP45EU Bedienungsanleitung Seite 4

Targus Universal Laptop Docking Station
Installing the Device and Drivers
To use the Targus docking station, you must first install the driver
onto your computer.
WARNING: YOU MUST INSTALL THE SOFTWARE BEFORE
CONNECTING THE DOCKING STATION TO YOUR COMPUTER.
OTHERWISE, THE DOCKING STATION WILL NOT WORK
PROPERLY.
After installing your software, connect the docking station to your
computer and Windows plug-and-play will install the hardware
drivers for each port.
Installing the Docking Station Driver
Installing the docking station driver enables your operating
system to recognize it and its ports once it's connected.
1 Turn on your computer.
2 Insert the driver software CD into your computer's CD-ROM
drive.
If setup does not begin automatically, click Start, Run, and enter
D:\ACP45_setup.exe (where D: is the path of your CD-ROM
drive) and then click OK.
6
Targus Universal Laptop Docking Station
3 The Installation Wizard window of the docking station will pop
up. Click Next to proceed.
7