SUBWOOFER CHANNEL
Set the volume control of your head-unit to approximately 3⁄4 of full volume, while
playing a dynamic track with good bass content. Slowly increase the input gain control
of the channel pair on the amp, driving the subwoofer(s), by turning the input LEVEL
potentiometer clockwise until you can just hear distorted sounds. Reduce the main
volume level of your head-unit to a medium listening level and continue to set the
remaining input gain levels, as described below.
SATELLITE CHANNELS
Slowly increase the input gain control of the remaining channel pair, for example the
section that drives the front door installed speaker system, by turning the LEVEL control
clockwise until you reach a good tonal balance with a slight emphasis of the bass
range. Finally turn up the input level gain of all remaining channel pairs if applicable,
to reach a good balance of the front, rear and subwoofer playback levels in your car.
You're done!
TECHNICAL SPECIFICATIONS
Modell
Peak Power Output
At 4 Ohms load / 14.4V (THD<=1.0%)
All channels driven simultaneously
Rated Power Output (RMS)
At 4 Ohms load / 14.4V (THD<=0.3%)
All channels driven simultaneously
Power Output
At 2 Ohms load / 14.4V (THD<=0.3%)
All channels driven simultaneously
Power Output
At 4 Ohms load / 14.4V (THD<=0.3%)
All channels driven simultaneously
Damping Factor
All Channels stereo @ 4Ohms/100Hz
Signal-to-Noise Ratio
(A-weighted - all channels)
Frequency Response
(all channels, frequency filtering
controls deactivated, 0 dB / - 1 dB)
Channel Separation
(all channels)
Input Sensitivity
(all channels)
Integrated Active Filtering
X-Over Slope Rates
Variable Cross-Over Frequency
Fuses
Dimensions (W x D x H) mm
SPA2200Z
100W x 2
93W x 2
128W x 2
250Wx1 bridge
> 100
> 82 dB
20 Hz - 40 kHz
> 45 dB
280 mV – 4.2 V
12 dB / oct.
32 – 320 Hz
1 x 25A ATC
292 x 250 x 62
18
SPA4100Z
75W x 4
62W x 4
81W x 4
154Wx2 bridge
> 100
> 79 dB
20 Hz – 40 kHz
> 45 dB
280 mV – 4.2 V
12 dB / oct.
32 – 320 Hz
2 x 20A ATC
334 x 250 x 62