Dmx-Mode; Dmx-Protocol - EuroLite LED SLS-7-QCL 7x10W Bedienungsanleitung

Slave mode
Press the MODE button until the display shows "SLAU", and you can select which devices should serve as
slaves. Press ENTER to confirm.
Dimmer mode
Press the MODE button until the display shows "rgbu"
You can select the desired brightness values via the UP or DOWN buttons.
Press the MODE button again and with ENTER select and confirm the flash speed.
You can select the desired values via the UP or DOWN buttons.
Modus:
rgbu

DMX-Mode

The device has different DMX channel modes. The Control Board allows you to assign the DMX channel
mode and the DMX fixture address, which is defined as the first channel from which the device will respond
to the controller.
Addressing
Press the MODE button until the display shows CH. You can now select between 5CH, 6CH or 8CH mode.
Press the ENTER button.
The display shows "d001". You can now set the desired address via the UP or DOWN buttons. Press
ENTER to confirm.
Please, be sure that you don't have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX-chain. If several devices are addressed similarly, they will
work synchronically.
Controlling:
After having addressed the device, you may now start operating it via your lighting controller.
Please see the following DMX protocol graphics for the respective channel values.

DMX-protocol

5 channel mode
Channel: Value:
1 000 – 255
Channel: Value:
2 000 – 255
Channel: Value:
3 000 – 255
Channel: Value:
4 000 – 255
Channel: Value:
000 - 063
064 - 223
5
224 - 255
Wert:
r
g
b
u
S
Function:
Red (0 – 100%)
Function:
Green (0 – 100%)
Function:
Blue (0 – 100%)
Function:
White (0 – 100%)
Function:
No function
Auto strobe with increasing
speed
Sound controlled strobe effect
Funktion:
Red (000 – 255)
Green (000 – 255)
Blue (000 – 255)
White (000 – 255)
00-16, with increasing speed
22/24 00089853.DOC, Version 1.1