Herunterladen Inhalt Inhalt Diese Seite drucken

Parrot MKi9000 Bedienungsanleitung Seite 13

Vorschau ausblenden Andere Handbücher für MKi9000:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 34
+12V supply, as you could run down the vehicle's battery.
On some vehicles, the red and orange power supply wires
may need to be reversed. This can easily be done by rever-
sing the two fuse holders on the Parrot MKi9000 installation
cable.
Many new vehicles do not have a 12 volt ignition supply.
The 12 V ignition must then be taken elsewhere on the
vehicle such as the fusebox or cigar lighter. An additional
device generating an artificial ignition 12V signal may also
be necessary.
Installing the audio connectors
The music cable grommet system allows you to adjust the
cable length while reducing its wear.
1.
Drill a 20 mm hole in your dashboard (glove compart-
ment or parcel tray).
2.
Insert manually two flexible arms of the grommet system.
3.
Use a flat screwdriver in order to insert the last two arms.
> You can now connect your music cable to the bluebox.
Installing the electronic box
Avoid installing the electronic box near heating or air-con-
ditioning system, on a spot directly exposed to sunlight or
behind metal walls.
Make sure the electronic box stays fixed once it is installed
and that it will not move while you are driving.
Do not reinstall the car stereo forcibly. If you are short of
space behind the car stereo to install the electronic box,
consider installing it in the glove box.
Installing the remote control
If you want to place the remote control on the steering
wheel, make sure it is securely attached, so it does not
move when you are driving. Do not install the remote con-
trol on the outside of the steering wheel and ensure it does
not get in the way when driving.
If you want to place the remote control on the dashboard,
stick the double-sided tape located on the flat side of the
bracket to fix it against the dashboard. You can then insert
the remote onto the bracket.
Once you have stuck the support on the dashboard,
wait for approximately 2 hours to make sure the
adhesive tape adheres well.
Installing the microphone
Make sure the microphone is installed as close to the mouth
of the user as possible. The ideal distance is 60 cm. The
best possible location for the microphone is near the rear-
view mirror.
The microphone needs to be pointed towards the user.
13

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis