Kärcher 150 Bedienungsanleitung Seite 9

ENGLISH
Spraying – Wiping – Vacuuming
How to achieve the best cleaning
results
Do not clean a surface while it exposed to
direct sunlight.
Dampen the fleece strip before you start
cleaning.
Make sure you hold the cleaning head handle
the correct way. see Fig.
!
Take care not to spray the water jet
into your eyes
Press the pump lever to spray water onto the
surface that is to be cleaned. It may be
necessary to press the lever a few times to
remove air from the system before water is
sprayed out of the nozzle.
Spray the glass surface evenly and from a
distance of 15 - 20 cm with as much liquid as
required without it running down the surface
of the window.
Remove the accumulation of dirt by wiping
over the surface with the felt strip.
Activate the vacuum system by pressing the
ON/OFF button on the main unit.
Draw the rubber blade over the glass surface
from top to bottom and at the same time
apply a small amount of pressure. The dirty
water is vacuumed off.
How to use your Window Washer
Complete the action by drawing the blade
sideways across the bottom edge of the
window, and then press the ON/OFF button
again to switch the vacuum system off.
After you have finished cleaning, hold the
cleaning head upright for a few seconds with
the vacuuming function switched on. This will
ensure that any dirty water left inside the hose
is sucked backed into the dirty-water tank.
Cleaning and storing the washer
refilled. Otherwise the water could over-
flow and damage the unit.
Always recharge the battery overnight before
storing the Window Washer.
The grip section of the cleaning head can be
fastened to the carrying handle on the main
unit for storage or transport purposes.
7
K 150
Turn the dirty-water
tank through 30º and
pull it off downwards.
Empty the tank.
!
The dirty-water
tank should always be
emptied before the
fresh-water tank is