Singer Infinity Pro 10002PW Bedienungsanleitung Seite 24

It is also possible to move the board in its vertical position thanks to the wheels
(29) as shown in the drawing.
USE
• Stand the ironing board with castors (12) and feet (11) on the floor.
• Lift the board and keep the safety catch pressed until the desired height is
reached (Fig.1). Carry out this operation very carefully.
• Make sure that the board cover is fitted properly; if necessary, proceed as follows:
1. Loosen the cord that keeps the board cover stretched.
2. Fit and spread out the cover; make sure that the two corners on the
3. Pull the cord firmly and fasten it with the cord fastener (8), (Fig.2).
4. Make sure that the cord fastener does not interfere with the safety catch
IMPORTANT: do not use any other covers over the ironing board
as they may prevent suction and blowing functions significantly.
• Take the iron out of its compartment and proceed as follows:
- Press both door catches inwards at the same time (24).
- Lift the door (25), (Fig. 3).
- At this point theiron and the power cord can be extracted.
- Close the door again and stand the iron on the mat (23).
Fig.1
ADVICE ON IRONING
Read the care label on the garment before beginning to iron and make
sure that the fabric is suitable to be steam ironed!
Before beginning ironing, the Antenna (16) can be fitted, a pratical system to
hold the wire, making movements easier and guaranteeing excellent ironing
always.
REFILLING
(A)
• The tank must be filled before using the product. If the water is particularly
hard (>14°dH/>15.5°e/>25.2°f), it is advisable to mix drink water with
demineralized water in equal parts.
• The tank may be filled in 2 ways:
control panel side fit properly.
in any way.
Fig.2
24
Fig.3