Axis P5512 Bedienungsanleitung Seite 11

AXIS P5512 Installation Guide
7. Remove the cable gasket and route the network cable. Remove the cable plug from the cable
gasket to route the multi-connector cable if there is one. Be careful not to damage the cables
when connecting to the network camera.
8. Put the camera base lid back in its original position and fasten the screws.
9. Secure the camera using the supplied safety wire.
Ceiling bracket
Ceiling tile
10. Slide the unit holders on the network camera into the slots on the mounting plate and rotate
the camera unit.
11. Install the ceiling tile, with the camera mounted, into the ceiling.
Page 11
Multi-connector cable
Network cable
Safety wire