auna 10030313 Anleitung Seite 29

Setup Wizard
Choosing this option will guide you to run the network setup from the beginning.
Info
This is to show the software version and Radio ID for your radio. This information is useful for you when
you need to report any technical issues to the help centre, you will be asked for these information.
Backlight
• Timeout: This option is to set the period of time that you wish your display's backlight to remain lit
after your last touch of any key of the remote control, when your radio is in both ON and STANDBY
modes. The available options are: On/10 sec/20 sec/30 sec/45 sec/60 sec/90 sec/120 sec/180 sec.
Selecting "On" will force your radio's backlight to remain on constantly. If you select a specific time
option, e.g.10 seconds, the display will dim down under the following two situations:
When the radio is turned on, the display will dim down in 10 seconds after you use your device.
When the radio turns off into standby, the backlight will dim down in 10 seconds if no buttons are
touched.
• On level: This option will determine how bright the display's backlight is lit while the radio is on ON
mode. There are 3 options for this setting: High, Medium& Low.
• Dim level: There are 3 brightness levels of the Dimmed backlight available – low/medium/high.
Turning on/off the Radio
To power on/off the radio, press the Power on/off switch at the rear side of the
unit. To turn it to Standby, press the Power button. It will switch to Standby. It will
display the clock and alarm time if it is set. To turn it ON again, do the same by
pressing the Power button.
29
www.auna.de