Changing A Program; Uncontrolled Heat Up; Checking Program Values - Pyrotec PY1 Bedienungsanleitung

Changing a program

900
850

Uncontrolled heat up

Ship

Checking program values

20
The following example explains how to change the firing
temperature of program P2 from its original value of
900°C to 850°C.
Select program P2 as described in the example before.
After pressing key (3) the display (1) shows the current
value of the program (900°C). The corresponding
indicators in firing curve (8) light up.
Use keys (7) to alter the value to 850°C. Keep the key
pressed for large changes in value. Changing the other
values of the firing works the same way. Press one of the
keys (3, 4, 5, 9) to show the current program value in
display (1) and adjust the value using keys (7) if required.
The program change is done permanent. The setting is
also stored when the controller is powered down.
However, all program values can be changed as often as
you like.
To start the firing with the new firing curve just press key
(10).
If you want to achieve the fastest possible start-up phase
(segment a), press the "t1" key (5) and adjust the value
by pressing the minus key (7) until "SKIP" is displayed.
All program values can be checked by pressing the
corresponding key (3, 4, 5, 9). This can be done at any
time also during a firing process without interrupting the
firing process.