Connecting The Dust Extractor - Batavia BT–CS016 Bedienungsanleitung

English
Make sure that the packaging contents
3.
are complete and free from possible
damage. Contact the retailer you
bought the product from or telephone
the After Sales Support number if you
notice that parts are missing or dam-
aged.
Do not use the product until missing
parts have been delivered or defective
parts have been replaced. The use of an
incomplete or damaged product may
lead to personal injury and damage to
property.
Ensure that you have the necessary
4.
accessories and tools for set-up and
use. This includes suitable personal
protective equipment.
Inserting and changing the fitted
6.2.
tool
WARNING!
Risk of injury!
Improperly inserting and changing the fitted
tools may result in injury.
Before working on the product, pull the
1.
mains plug out of the socket.
Do not use any defective fitted tool or
2.
tools that are cracked or chipped.
Check the fitted tool for damage before
inserting it.
Do not use any flange/flange nuts if
3.
their hole is larger or smaller than the
hole in the fitted tool.
Only use fitted tools of the same type
4.
as those shipped with the product.
Release the cutting depth limiter(9).
5.
Hold the spindle lock (18) down and
6.
turn the spindle (11) until it locks into
place.
Use the star hex key (23) to loosen the
7.
clamp bolt (13) by turning it clockwise
and remove it with the clamping flange
(12). Do not remove the support flange
(10) from the spindle (see Fig. 1, steps
1–4).
Push the access switch for the protec-
8.
tive hood (3) and hold it in position.
Open the protective hood (16) com-
9.
pletely, hold it in position and let go of
14
7063051-Thor-Compact-Ma-1804-30.indb 14
the access switch for the protective
hood (3) (see Fig. 2, steps 1–2).
Select a suitable fitted tool (25, 26) for
10.
the material you intend to work on.
Insert the fitted tool. Make sure that the
11.
fitted tool rotates in the right direction
(see the jagged arrow on the housing).
Then close the protective hood (16)
(see Fig. 3).
Insert the clamping flange (12) and the
12.
clamp bolt (13) into the spindle. Tighten
the clamp bolt by turning the star hex
key (23) anticlockwise.
Check if the fitted tool is fitted correctly,
13.
moving parts run smoothly and the
clamp bolt is tightened.
Before working with the product, let it run
idle for one minute after changing/inserting
a fitted tool to ensure that the fitted tool has
been correctly inserted.
Mounting the parallel guide
6.3.
Do not use a parallel guide if the cutting
width of the work piece is smaller than
5 mm.
Fix the parallel guide from the left-hand side
to saw along parallel to straight work piece
edges.
Loosen the locking knob (15a) by turn-
1.
ing it anticlockwise.
Slide the parallel guide 15 through the
2.
end stop guides (see Fig. 4, steps 1–2).
Adjust the parallel guide until the
3.
desired width is shown on the scale
(15b).
Tighten the locking knob (15a) clock-
4.
wise to secure the parallel guide.

Connecting the dust extractor

6.4.
WARNING!
Risk of injury!
Harmful/toxic dust can be produced when
working on e.g. paint coats containing lead
and some types of wood. They pose a dan-
ger for both the user and nearby persons.
– If you cut materials that could produce
hazardous dust, always use a dust
extractor. This also applies, among
other things, to hard woods, MDF pan-
els and ceramics.
04-06-18 11:55