Dab+ Operation - auna 10031949 Bedienungsanleitung

EN
32

DAB+ OPERATION

If the unit is connected to the mains power and then switched on from
standby for the first time, the unit will automatically enter into the DAB
mode and perform auto scan function. During the scan the display will show
"Scanning..." together with a slide bar that indicates the progress of the
scan and the amount of stations that have been found so far.
Once the scan has finished, the unit will select the first alphanumerically
found station. To explore the found stations, press the |<< or >>| buttons.
Full Scan
The full scan will search for the entire DAB+ Band III channels. After the scan
has finished, the first alphanumerically found station will be automatically
selected.
1 To activate auto scan, press the SCAN button and the display will show
"Scanning ..." and a progressing slide bar.
2 All the stations that have been found will be stored automatically. To
explore and listen to the found stations, press the |<< or >>| buttons to
select. Then press the ENTER button confirm into stations.
Manual Tuning
As well as the auto tune function, you can manually tune the receiver. This
can help you when aligning your aerial or when adding stations that were
missed while auto tuning.
1 Press the MENU button on the remote control to display the menu.
2 Press the ENTER button to select Manual tune.
3 Press thebuttons to cycle through the DAB+ channels, which are
numbered from 5A to 13F.
4 After your desired channel number is selected, press the ENTER button
to confirm. The display will show the multiplex.
5 Press the MENU button again to add selected channel to station list.