Operation - patura p1 Bedienungsanleitung

to a battery and solar panel(s). For further information about solar installations, please refer
to our "Electric Fencing Catalogue".

Operation

Once the energiser is connected to the line power supply or the battery it will begin to operate
automatically. The pulse light flashes with every pulse
.
Battery selection and management
This section refers exclusively to rechargeable, lead­acid batteries, for example car, tractor,
truck, marine or specialist deep­cycle batteries. The size of battery you select will depend on
the model of energiser you have.
Battery selection
As a guide, the recommended battery size in amp hour (Ah) required for each energiser
model is shown below. This table is based on a 8 day operating period between battery
charging. Although operating time can exceed 8 days, this is likely to cause battery damage
and will necessitate frequent replacement of the battery. For best system reliability and long
term battery life, the preferred battery and charging regime is to use a deep­cycle, lead­acid
battery and to recharge it when it has discharged to about half­way.
Energiser Model
P1
P2
P3
P4
P5
Warning! A rechargeable 12 V lead­acid battery must be used.
Battery management
Warning! Batteries contain harmful chemicals and when used incorrectly, may cause injury.
Observe the guidelines for battery care, maintenance and safety in this manual and in the
documentation supplied with your battery.
Battery preservation
In order to extend the operating period between battery charges, the energizer will begin to operate
at a slow speed and half output energy when the battery capacity drops below approximately 40%.
In order to prevent deep discharge and thus irreversible damage to the battery, the energizer will
stop producing output pulses when the battery capacity drops below approximately 20%.
Current required
60 mA
100 mA
195 mA
320 mA
450 mA
- 30 -
Battery capacity
20 Ah
35 Ah
65 Ah
105 Ah
150 Ah