Stacked Installation (Example Of 1 Vio-L210 Module On Vio-S118) - dBTechnologies VIO-S118 Bedienungsanleitung

STACKED INSTALLATION (EXAMPLE OF 1 VIO-L210 MODULE on VIO-S118)

• It is possible to install a maximum of 3 modules in stacked configuration on the GSA-
ViOL210 accessory. 3 modules with DRK-210. The maximum number of ViO-S118 is 2.
• It is possible to use both GSA-VIOL210 and DRK-210 accessory.
• Use he DBTECHNOLOGIES COMPOSER to set the project parameters, for safety reasons.
• Position GSA-VIOL210 or DRK-210 accessory (installed on a flat surface) on SUB S118. For
further details on this accessory, refer to the relevant manual.
• Add VIO-L210 modules one by one, with the previously-calculated angle, as shown in
MECHANICS
• Make sure that the local parameter of the different modules are correctly set on the
single amplifier panels. In particular, verify according to the project, Audio Attenuation,
Speaker Coupling and High Frequency Compensation settings. As an alternative, all
parameters can be remotely edited in real time or at a later stage in case of line-array
connection through the RDNet network (DBTECHNOLOGIES NETWORK). Nevertheless,
project initial settings should at least be physically repeated on the VIO-L210 modules
before installation. For further information see
CONTROL section.
• Make the audio daisy-chain, RDNet and power connections as described in previous
paragraphs.
WARNING
•
•
VIO-S118
58
paragraph.
!
If the support surface presents even the slightest inclination, it is necessary to
properly fasten using the appropriate mechanical means and/or installation
straps.
For any further information about the accessories it is mandatory to consult
the relevant instructions
DSP PRESET PARAMETERS AND REMOTE
English
Cod. 420120259 REV. 1.0