Connections; Connection And Power Daisy Chain - dBTechnologies VIO-S118 Bedienungsanleitung

3. CONNECTIONS

CONNECTION AND POWER DAISY CHAIN

SUBWOOFER 1
The figure above shows a general connection where a module 1
is over module 2. For this purpose, use cables with powerCON TRUE1® connectors (not provided).
• Connect the power supply of module 1 AUTO-RANGE MAINS INPUT (A).
• Link the power supply from module 1 to module 2 connecting the output MAINS LINK (B) of module
1 to the input AUTO-RANGE MAINS INPUT (C) of module 2.
• Repeat this procedure until connecting the maximum permitted number of the line-array module
(refer to section SPECIFICATIONS).
WARNING
• The cables must be properly sized and the system's design, installation and
testing should be performed by qualified personnel only. AEB industriale declines
any responsibility in case of cables that are non-compliant, uncertified and
incompatible with the proper layout of the system and the regulations in force
for the country of use.
VIO-S118
50
!
SUBWOOFER 2
Cod. 420120259 REV. 1.0
English