Rear View - dBTechnologies VIO-S118 Bedienungsanleitung

English
• Carry out wiring between the subwoofers as explained in
CONNECTIONS chapter.
• Lift the 3 VIO-S118 modules using one or two engines and the
appropriate means for rigging (not provided), so as to easily remove
the DO-VIOS118 dolly.
• Transport, through DT-VIOL210, the first 4 ViO-L210 modules to the
spot in which the line array will be lifted. Have a second dolly ready
with other 4 modules for the following assembly stages.
• Fix the brakes on the DT-VIOL210 wheels.
• On the back, insert the movable arms into the brackets as shown in
the ViO-L210 manual.
• Insert the pins corresponding to the previously calculated angles
inside the arms (for this operation, you do not need to lift the
modules).
• Carry out wiring between ViO-L210 modules (see the relevant
manual).
• Remove the top cover and the tubes on the back of DT-VIOL210.
• Fit FSA-VIOL210 on the back (in the upper ViO-L210) as shown,
according to the accessory instructions.
• Position ViO-S118 subwoofers at the height suitable for the hook.
• Complete hooking of ViO-L210 modules to ViO-S118 subwoofers on
front and rear side.
• Remove the brakes from the empty DT-VIOL210 wheels and put it
back in the rest position.
VIO-S118

REAR VIEW

Cod. 420120259 REV. 1.0
55