Installation And Configuration; Flown Installation (Example Of 1 Array With 3 Vio-S118 In Cardioid And Configuration And 8 Vio-L210) - dBTechnologies VIO-S118 Bedienungsanleitung

5. INSTALLATION AND CONFIGURATION

FLOWN INSTALLATION (EXAMPLE OF 1 ARRAY WITH 3 VIO-S118 IN
CARDIOID AND CONFIGURATION AND 8 VIO-L210)
THE CONNECTIONS SUGGESTED
IN THE FOLLOWING PICTURES
ARE FOR INFORMATION ONLY.
• Use DBTECHNOLOGIES COMPOSER (from rev.6.3.0 or later) to set installation parameters
• Make sure that the local parameters of the different modules are correctly set on the single
amplifier panels. As an alternative, all parameters can be remotely edited in real time if the
connection is carried out through the RDNet network (DBTECHNOLOGIES NETWORK). In this case
it is also good practice to physically replicate the initial settings on the VIO-S118 and VIO-L210
modules before the installation. For further information see the
• Transport through DO-ViOS118 dollies the 3 ViO-S118 subwoofers fitted in cardioid configuration,
as shown (for further information, see MECHANICS section of this manual). Place brakes to the
dolly. The DRK-210 fly-bar has already been installed on subwoofer top (in accordance with the
accessory instructions).
VIO-S118
54
REMOTE CONTROL section.
Cod. 420120259 REV. 1.0
English