Features Of The Amplifier And Control Sections; Remote Control - dBTechnologies VIO-S118 Bedienungsanleitung

FEATURES OF THE AMPLIFIER AND CONTROL SECTIONS

The class D digital amplifier is the heart of the
VIO-S118 subwoofer.
It allows delivering up to 1600 W RMS, silently and
efficiently, without ventilation. System is controlled
by a powerful DSP allowing an immediate and
quick configuration.
Thanks to the possibility of a networking
with RDNet, the parameters on the panel
can be remotely controlled through the
"DBTECHNOLOGIES NETWORK" software (refer to

REMOTE CONTROL

paragraph).
The DIGIPRO G4 panel is made up of:
• Input, Output and Control Section
• Power Supply Unit Section
!
WARNING
• Do not obstruct the rear heat sinks
of the amplifier. If the module heats
up excessively, the audio volume is
gradually reduced until the module
is thermally stabilised. The audio
is automatically restored when the
normal operating temperature is
reached.
• Never attempt to disassemble the
amplifier in any way.
• In the event of a malfunction,
remove power supply immediately
by disconnecting the unit from
the power mains and contact an
authorised repair centre.
• The fuse installed at the factory is
rated for operation in the 220-240
V voltage range. If you need to
operate the speaker in the 100-120
V range:
1.
2.
3.
VIO-S118
42
Disconnect all connections,
including the power supply
connection.
Wait 5 minutes.
Replace the fuse with the
fuse rated for the 100-120 V
range, which is included in
the package.
English
Cod. 420120259 REV. 1.0