Panasonic CZ-RE2C2 Bedienungsanleitung Seite 5

Display Section
/ / /
1.
indication
The selected fan mode is displayed.
2. (Flap position) indication
Indicates the flap position.
3. (Swing) indication
Appears while the flap swings.
4. (Outing) indication
( Outing Function)
Appears when the outing function is set.
5. Operation Mode indication
Displays the selected operation mode.
(AUTO /HEAT
FAN ).
6. Upper and lower limit indication of the
outing function
: Indicates the upper limit of the
temperature
: Indicates the lower limit of the
temperature
7. Temperature indication
Indicates the set temperature.
8. °F / °C (Temperature unit) indication
9. (Remote control sensor) indication
Appears when the remote control sensor is
used.
(Fan mode select)
/DRY /COOL /
10. (Centralized control) indication
Appears when operated in centralized control.
If the remote control operation is not permitted
to the remote unit, when the
button, (Mode select) button,
(Fan speed) button,
button or
buttons are pressed,
rejects the change.
11. (Disabled feature) indication
Displayed if the selected feature was disabled
during installation.
12. (Heating standby mode) indication
appears when the fan of the indoor unit is
stopped or in low fan speed.
13. (Caution) indication
Appears when the protective device is
activated or when an abnormality occurs.
14. Alarm indication
This displays alarm messages when an error
occurs.
15. (Oil) indication
Appears when the engine oil needs to be
changed. (Appears when the gas heat pump
air conditioner is used.)
EN-3
(Start/Stop)
(Swing/Air direction)
(Temperature setting)
flashes and
EN