Installation; Wiring - SOMFY PERGOLA TILT IO Anleitung

Control Unit PERGOLA TILT IO

2. INSTALLATION

Cables which pass through a metal wall must be protected and insulated using a sheath or sleeve
For outdoor use, install the Pergola Tilt io Control Unit cables in a UV resistant duct, for example
under trunking.
Instructions which must be followed by the drive and home automation professional installing the
Pergola Tilt io Control Unit.
Never drop, knock, drill or submerge the receiver.
Install a separate control point for each drive.
Ensure the power is switched off during the assembly and wiring stages.
2. 1. INSTALLATION
Overall size of the mounting holes in millimetres.

2. 2. WIRING

The length of the cables must not exceed 30 metres
Cut the grommet membrane.
1)
Remove the wiring connectors.
2)
Insert the cables. Be careful of the cable raceways so that
3)
water ingress is prevented. Do not insert more than one cable
per grommet (diameter of the cables between 5 and 9 mm).
Strip the wires (maximum 5 mm) and tighten the wires in
4)
the connectors.
Copyright 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
57
99
1) 2)
3) 4)
EN
79
Ø4.8
19