Commissioning - SOMFY PERGOLA TILT IO Anleitung

EN

2. 5. COMMISSIONING

2. 5. 1. Automatic adjustments of end limits
The drive's end limits must match the Pergola's end limits.
Press the PROG button on the circuit board for over
1)
2 seconds until the S1 and S2 LEDs flash, then release
(the pergola makes up and down movements).
Select the desired output by briefly pressing the PROG
2)
button, the LED corresponding to the selected output
flashes. If the circuit board only has one pergola, move on to
the next step (sending information on the selected output).
On the io Situo 1 or io Situo 5 control points, select the
3)
desired channel.
Press "Up" and "Down" at the same time until the selected
4)
pergola reacts.
Press the "Up" button to check the direction of rotation:
5)
If the motorised product opens, the direction of rotation
•
is correct.
If the motorised product closes, the direction of rotation
•
is incorrect. Press the "My" button until the motorised
product moves up and down: the rotational direction has
been modified.
Press the "Up" button to check the direction of rotation.
6)
Press "Up" and "Down" at the same time.
7)
Do not interrupt the movement: the drive will search for its
upper end limit automatically.
Position the pergola in the desired position for ice
8)
(press and hold down the "Up" or "Down" button).
Confirm the settings by pressing "My" for more than
9)
2 seconds (sends the information to the desired output).
Briefly press the PROG button on the back of the io control
10)
point until the selected output responds. The end limit
positions have been programmed.
22 Copyright 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
Control Unit PERGOLA TILT IO
1) 2)
> 2 s.
3) 4)
1.. 2..3.. 4.. 5..
5)
6) 7)
8) 9)
10)
PROG.
< 0.5 s.
The direction
of rotation is
correct
> 2 s.