Use And Maintenance; Using The Io Control Points; Adding And Removing The Favourite Position; Using Sensors - SOMFY PERGOLA TILT IO Anleitung

EN

3. USE AND MAINTENANCE

This receiver is maintenance-free.

3. 1. USING THE IO CONTROL POINTS

Drive output: Opening.
1)
Drive output: Closing.
2)
Drive output: STOP or Favourite Position.
3)

3. 2. ADDING AND REMOVING THE FAVOURITE POSITION

Besides the upper and lower position, an intermediate position known as the "favourite position
(my)" may be programmed in the drive.
Place the motorised product in the desired favourite
1)
position (my).
Press the "My" button until the motorised product moves up
2)
and down: the new favourite (my) position is programmed
and the previous favourite (my) position is deleted.

3. 3. USING SENSORS

3. 3. 1. Operation of the sensors
Protection against the wind (requires the wind sensor):
Depending on the position of switch 5, the slats open or close
in the event of wind.
Protection against rain (1) (requires the rain sensor)
In the event of rain, the slats close completely.
Anti-freeze protection
In the even of ice, the pergola positions itself at the position
defined by the settings.
The temperature sensor is integrated into the central unit. The triggering threshold will depend on the
installation conditions.
(1)When the rain sensor is active, refer to the control point instructions
24 Copyright 2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
Control Unit PERGOLA TILT IO
1) 2)
3)
1) 2)