Installation Instructions; Symbol Description; En Instructions For Use / Assembly Instructions - HANSGROHE Metropol Classic Gebrauchsanleitung, Montageanleitung

Safety Notes
Gloves should be worn during installation to
prevent crushing and cutting injuries.
The product may only be used for bathing,
hygienic and body cleaning purposes.
Do not allow the streams of the shower touch
sensitive body parts (such as your eyes). An
adequate distance must be kept between the
shower and you.
The product may not be used as a holding han-
dle. A separate handle must be installed.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for
transport damages. After it has been installed, no
transport or surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
Safety against backflow
The product is exclusively designed for drinking
water!
4
English
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 70°C
65°C
max. 70°C / 4 min
Assembly see page 31

Symbol description

Do not use silicone containing acetic
acid!
Dimensions (see page 35)
Flow diagram (see page 35)

Hand shower

Bath Spout
Operation (see page 40)
Maintenance check valve
(see page 36)
The check valves must be checked
regularly according to DIN EN 1717 in
accordance with national or regional
regulations (at least once a year).
Maintenance Secuflex hose
(see page 36)
Repeat cleaning when pull out becomes
difficult.
Cleaning (see page 42) and
enclosed brochure
Spare parts (see page 38)
XXX = Colors
000 = chrome plated
090 = chrome plated/gold plated
990 = gold plated