Herunterladen Inhalt Inhalt Diese Seite drucken

Functions - dB Technologies MOVING ONE-H Bedienungsanleitung

Funksysteme
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1)
ON/OFF BUTTON
Pressing and holding the button for a few seconds, the transmitter switches on and the LED
(2) turns on.
To switch off the transmitter, press and hold the button for at least 1 sec (the LED will turn off
automatically).
2)
"POWER" LUMINOUS INDICATOR
The LED indicates the status of the transmitter and of the battery.
LED off:
LED on (steady):
Flashing LED:
Red LED:
3)
MICROPHONE/GUITAR INPUT
This input is used to connect a microphone.
Use a 4-pole MINI XLR connector.
4)
"AUDIO/PEAK" LUMINOUS INDICATOR
It is used to indicate the different modes of operation
OFF:
GREEN:
RED:
5)
"IR"
Dedicated window for device communication via infrared (IR) with the receiver MOVING
ONE-RX. Refer to the procedure specified below for details.
6)
THREE POSITION SENSITIVITY SWITCH
Selects the sensitivity depending on the type of source used
HIGH +10dB
0dB
LOW -10dB
7)
ANTENNA
Flexible. It allows the transmission of the signal.
8)
BATTERY DOOR
Battery compartment
9)
BELT CLIP
Allows to clip the receiver to a belt or to the belt of the guitar.

4.2. Functions

Power on
Press and hold the ON/OFF button for a few seconds; the status LED (2) turns on and indicates
the status of the transmitter.
Power off
Press and hold the ON/OFF button for about 1 sec.; the status LED (2) turns off.
transmitter off
transmitter on and operating
transmitter synchronization with the receiver in progress
dead batteries
(the batteries must be replaced)
no or very low audio input signal.
audio communication in input
signal with very high audio level input
to be used in case of headset microphones
to be used in case of headset microphones or connections with
instruments
to be used in case of connections to instruments (guitars, bass, ...)
ENGLISH
24

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Moving one-bMoving-one

Inhaltsverzeichnis