Suggestions And Recommendations - dB Technologies MOVING ONE-H Bedienungsanleitung

6.

SUGGESTIONS AND RECOMMENDATIONS

Check that receiver and transmitter have the same operating frequency.
Any transmitter can only work if it is used with the receiver operating in the same band
and frequency.
ATTENTION
Before supplying power to the receiver, make sure that the mains voltage corresponds to the input
voltage indicated on the power supply.
The receiver must be supplied solely and exclusively with the included power supply.
Supply power to the receiver by connecting the power supply to the connector "DC MAIN INPUT"
located at the rear of the receiver.
Interference problems
To avoid interference problems:
- keep the transmitters at least 1/1.5 metres away from ANY receiver
- should the transmitter and the receiver have to operate at less than 1m from each other,
fully lower the transmitter antenna.
- the effective range depends on the presence of any noise on the selected channel, of
obstacles between transmitter and receiver or of signal reflections linked to the usage
environment.
Simultaneous use of multiple systems
MOVING ONE is suitable for simultaneous use of several systems (up to 8 for each band
depending on the operating band).
All the frequencies of each group have been mathematically calculated to avoid intermodulation.
You can then get a good performance even in the case of multiple Moving One microphones used
simultaneously within the same group.
In case of problems during the simultaneous use of several systems, check the frequencies in
use, in particular check for multiple systems on the same frequency
In case of interference:
- turn off all the transmitters and check if the "RF" led on the receiver flashes in green; this
allows to identify a possible direct source of external interference
- turn on one transmitter at a time and check that only the corresponding receiver synchronizes
by checking that the "RF" led is steadily Green.
The same criterion for the choice of frequency should also be applied if you use the system
MOVING-ONE together with other radiomicrophones
Setup
Make sure that all the transmitters are off and all the receivers are on
- scan the group on a receiver (pressing and holding the "GROUP" button for 2 sec.)
•
the display shows the state of the automatic search
•
the receiver will select the group with the greatest number of channels recognized
as free
•
the receiver will indicate the first free channel of that group.
- Proceed with the synchronization of the corresponding transmitter (as per the dedicated
description) and leave it on
- Manually place all the other receivers on the group identified by the first receiver
- scan the channel on another receiver (pressing and holding the "CHANNEL" button for 2 sec.)
•
the display shows the state of the automatic search
•
the receiver will select the freest channel within the set group.
ENGLISH
28