Hand Transmitter (Moving-Txh); Controls And Functions - dB Technologies MOVING ONE-H Bedienungsanleitung

ENGLISH
3.

HAND TRANSMITTER (MOVING-TXH)

The transmitter can operate with a maximum of 77 channels, depending on the operating band,
divided in 10 groups in the UHF band.
Channel change takes place via the infrared communication from the receiver.
The microphone with dynamic suspension condenser capsule ensures a high quality of sound
reproduction with minimum handling noise.
ATTENTION
The transmitter and the receiver must operate on the same frequency.

3.1. Controls and functions

1) ON/OFF BUTTON
Pressing and holding the button for a few seconds, the transmitter switches on and the LED
(2) turns on.
To switch off the transmitter, press and hold the button for at least 1 sec (the LED will turn off
automatically).
2) LUMINOUS INDICATOR/LOCK BUTTON
The LED indicates the status of the transmitter and of the battery.
LED off:
LED on (steady):
Flashing LED:
Red LED:
3) SENSITIVITY SWITCH
Selects the sensitivity of the capsule.
H (HIGH +10dB)
L (LOW
4) "IR"
Dedicated window for device communication via infrared (IR) with the receiver MOVING
ONE-RX. Refer to the procedure specified below for details.
21
transmitter off
transmitter on and operating
transmitter synchronization with the receiver in progress
dead batteries
(the batteries must be replaced)
use this if the microphone is far from the source or the
source level is low
0dB) use this for vocals and speech
MOVING-ONE Diversity wireless microphone system