Phantom Power - dB Technologies MOVING ONE-H Bedienungsanleitung

ENGLISH
Selection of the channel
Only via the IR command from the receiver.
a) Align the transmitter and the receiver at a distance
of 20/30cm
b) Press and hold for two seconds the "SYNC"
button on the receiver:
- The "SYNC" LED on the receiver begins to flash
for 5 sec.
- The "POWER" LED on the transmitter flashes
as soon as the synchronization has been
achieved.
c) Once synchronization is achieved, the transmitter
will immediately begin to transmit on the preset
channel.
Battery replacement
a) Slightly press the compartment door (Figure A).
b) Fully open the door (Figure B)
c) Insert or replace the batteries in the compartment,
paying particular attention to the polarities indicated
on the bottom + /- (Figure C)
d) Close the battery door paying particular attention that
it is properly closed (Figure D)
Antenna
The antenna is made of flexible material to allow a better use. Never cover the antenna during
use.

PHANTOM POWER

The phantom power supply (6Vdc) is always present on the microphone input connector. Always
use the supplied accessories; never short the phantom power with the ground to avoid damage to
the transmitter.
Refer to the dedicated section in the manual for the connections
Customization of the transmitter
Five coloured silicone rings are provided for the customization of
a transmitter in the case of simultaneous use of multiple systems
(multiple microphone setup)
The coloured ring must be inserted into the connector of the
accessory in the position indicated in the figure to allow correct
insertion.
25
MOVING-ONE Diversity wireless microphone system